Constraints selection in Sketcher Workbench

Everything about FreeCAD. Tips and Tricks, special questions in problem-cases, but also newbie-questions are welcome. This is also a good place to show your FreeCad-project and build-reports.
*** we speak english ***
Beiträge: 29
Registriert: Mi 3. Jul 2019, 19:46

Constraints selection in Sketcher Workbench

Beitrag von BBScar » Fr 8. Nov 2019, 10:40

If you draw a sketch using the sketcher workbench and you got following error message shown in this picture:

Sketcher_ErrorMessageOnExtrusion.png (169.9 KiB) 3493 mal betrachtet

then you have a disconnection of your drawing, that would result in an open shape. This would make extrusion to a 3D shape impossible, so this error occurs.

I had to move the lines for hours to find this disconnected lines. The my delight, I found a selection option, that might help you as well, if you did not already know it:

FreeCad_Sketcher_Constraints.jpg (116.79 KiB) 3493 mal betrachtet


Zurück zu „FreeCAD Usergroup OSE international“