Seite 1 von 1

Constraints selection in Sketcher Workbench

Verfasst: Fr 8. Nov 2019, 10:40
von BBScar
If you draw a sketch using the sketcher workbench and you got following error message shown in this picture:

Sketcher_ErrorMessageOnExtrusion.png
Sketcher_ErrorMessageOnExtrusion.png (169.9 KiB) 3006 mal betrachtet

then you have a disconnection of your drawing, that would result in an open shape. This would make extrusion to a 3D shape impossible, so this error occurs.


I had to move the lines for hours to find this disconnected lines. The my delight, I found a selection option, that might help you as well, if you did not already know it:

FreeCad_Sketcher_Constraints.jpg
FreeCad_Sketcher_Constraints.jpg (116.79 KiB) 3006 mal betrachtet